VBUS sense - high if VBUS is present, else low The RP2040 GPIO used inside W5100S-EVB-Pico is as follows. If you are using the Ethernet function, these pins cannot be used for any other purpose. These pins enable SPI communication with W5100S to use Ethernet function. However, GPIO16, GPIO17, GPIO18, GPIO19, GPIO20, GPIO21 are connected to W5100S inside the board. It has the same pinout as the Raspberry Pi Pico board. W5100S-EVB-Pico pinout is directly connected to the GPIO of RP2040 as shown in the picture above. If you are looking for pinout of version 1.0, click here. Hardware Specification Pin-out v1.1 Above image presents pinout for v1.1.

40 pin 21x51 'DIP' style 1mm thick PCB with 0.1' through-hole pins also with edge castellations.

Micro-USB B port for power and data (and for reprogramming the Flash).

Internal 16 Kbytes Memory for TX/ RX Buffers.Supports 4 Independent Hardware SOCKETs simultaneously.Supports Hardwired Internet Protocols: TCP, UDP, WOL over UDP, ICMP, IGMPv1/v2, IPv4, ARP, PPPoE.

Can emulate interfaces such as SD Card and VGA.Flexible, user-programmable high-speed IO.2 × Programmable IO (PIO) blocks, 8 state machines total.1 × Timer with 4 alarms, 1 × Real Time Counter.2 × UART, 2 × I2C, 2 × SPI, 16 × PWM channels.12-bit 500ksps Analogue to Digital Converter (ADC).30 multi-function General Purpose IO (4 can be used for ADC).High performance full-crossbar bus fabric.External Quad-SPI Flash with eXecute In Place (XIP).264kByte multi-bank high performance SRAM.RP2040 microcontroller with 2MByte Flash.Ethernet (W5100S Hardwired TCP/IP CHIP).W5100S-EVB-Pico is a microcontroller evaluation board based on the Raspberry Pi RP2040 and fully hardwired TCP/IP controller W5100S – and basically works the same as Raspberry Pi Pico board but with additional Ethernet via W5100S.

Download raspberry pi pico pinout